Recent content by nrobfd_pl

  1. N

    Wiring Diagram for Automatic Pool Covers Inc Motor?

    The last two times I've tried to open my cover, the switch doesn't function (nor does bypassing the switch). These were a few weeks apart. I functioned well all season except I had to replace the switch midway though. Now, when this happens, the motor doesn't make any noise at all. Each time...
  2. IMG_1957.HEIC.jpeg

    IMG_1957.HEIC.jpeg

  3. N

    How to fix gap between coping and concrete?

    Is this just a cosmetic problem? Or is it more of an urgent issue?
  4. N

    How to fix gap between coping and concrete?

    Is there a temporary fix I can do to keep water from getting in there? To replace the coping, I'm assuming that means new concrete as well?
  5. N

    How to fix gap between coping and concrete?

    I know at some point, we’ll need to replace the coping and concrete. But for now, how do I fill these gaps?
  6. IMG_1733.jpeg

    IMG_1733.jpeg

  7. N

    FC Up & Down - Do I need to SLAM

    Yep. Comparing my numbers to your 9.6 FC / 24 hours, I came up .8 FC short. That's close enough for me considering all the variables at play. Thanks for all your help @Newdude in walking me through this!
  8. N

    FC Up & Down - Do I need to SLAM

    6/26 9:14pm FC - 8.4 6/27 7:43am FC - 11.8
  9. N

    FC Up & Down - Do I need to SLAM

    It was definitely on Superchlorinate because I turned it off in the morning after the test. My schedule looks like this: Pool - 12:00am-12:00am (1300 rpm) Pool High - 9:00am-9:15am (2900 rpm - purges bubble from pump basket) Skim - 9:15am-10:15am (2100 rpm) Skim - 2:15pm-3:15pm (2100 rpm) The...
  10. N

    FC Up & Down - Do I need to SLAM

    Nope, Superchlorinate was on Edit, if it matters, we had 8 people in the pool during the afternoon
  11. N

    FC Up & Down - Do I need to SLAM

    6/23 9:07pm FC - 9.2 6/24 7:11am FC - 11.4 @Newdude, I trust this means the SWG is functioning properly now?
  12. N

    FC Up & Down - Do I need to SLAM

    Ok, will still let it run tonight and test in the morning but: 6/23 7:21am FC - 6 6/23 9:07pm FC - 9.2
  13. N

    FC Up & Down - Do I need to SLAM

    Follow up, I was looking at my NodeJS-PC Dashboard and saw "Low Flow" under my IC60. Flow was green when I was out there earlier, but it was red this time when I went out. Perhaps it's doing this regularly causing the cell not to produce. I turned the pump up 100rpm and I'll run the test again...
  14. N

    FC Up & Down - Do I need to SLAM

    The cell was purchased new in March and installed in April. All lights are good. I'll check it for buildup later today. Also maybe relevant, it was on super chlorinate during the day yesterday as well. 6/22 5:41am FC - 3.2 6/22 9:18pm FC - 5.8
  15. N

    FC Up & Down - Do I need to SLAM

    Here are the results from tests last night / this morning: 6/22 9:18pm FC - 5.8 6/23 7:31am FC - 6