Recent content by nepool1

  1. N

    After startup - pool pump not pulling enough water

    I'll give it a shot, thanks!
  2. N

    After startup - pool pump not pulling enough water

    Hi All, started up my pool this year and the pump capacitor went out. No big deal, I diagnosed quickly and replaced with the same capacitor and it started right up. I had initially taken the bolts off the motor to the housing to check the impeller didn't have anything lodged into it. Once...
  3. N

    Can't get pool pump to pull after winter-ization

    @ferretbone - worked like a charm after about 3 times. thanks for the help!
  4. N

    Can't get pool pump to pull after winter-ization

    @ferretbone makes sense, i understand it conceptually, let's see what I can do. To answer others questions, the pump itself is probably 2' or close to that above the skimmer (although about 25' away). Obviously i can't do it via the skimmer with the pool level as of now. We'll try walking it...
  5. N

    Can't get pool pump to pull after winter-ization

    its def. sealing as i turn the valve to off and fill itup and it doesn't drop down...same with the cap, i can hear the air suction when i open it up. i guess the pump is just tired, bummer.
  6. N

    Can't get pool pump to pull after winter-ization

    Ok here is some more @Newdude @Texas Splash - video of me priming (it takes in water for about 30 seconds or more). The drain is constantly moving to the lowest point of resistance so water never really builds up. I close it up and turn it on. I get an initial "splash" of water in and it never...
  7. IMG_8358 Large.jpeg

    IMG_8358 Large.jpeg

  8. IMG_8363 Large.jpeg

    IMG_8363 Large.jpeg

  9. N

    Can't get pool pump to pull after winter-ization

    @Texas Splash - is it suitable to just have the diverter valve open to both the skimmer and floor drain? I have hose running in the skimmer as well to push from the other side...didn't help. maybe just need to make sure it's all good. To be clear the sand filter is empty (but re-hooked up and...
  10. N

    Can't get pool pump to pull after winter-ization

    hi all, I winterized my pool by blowing out all the lines and putting in some RV antifreeze into a couple areas. I got distracted and didn't finish cleaning it that day before putting on the cover - therefore i'm back to needing to drain it down a bit and getting more junk out. I went to turn on...
  11. N

    New pool owner - Added salt system - Need help balancing water - Foamy - Photos

    Posted new post here Staining - what to test for?
  12. Screen Shot 2022-05-25 at 11.07.40 AM.png

    Screen Shot 2022-05-25 at 11.07.40 AM.png

  13. N

    Staining - what to test for?

    Hi all - Started pool up this year, finally killed the cloudiness. I noticed it was a tad low so i filled it up for a couple of hours with the garden hose. I noticed some parts of the steps and liner stain a bit...is this from my hardly hard water? My water hardness without running through the...
  14. Screen Shot 2022-05-25 at 11.07.40 AM.png

    Screen Shot 2022-05-25 at 11.07.40 AM.png

  15. N

    New pool owner - Added salt system - Need help balancing water - Foamy - Photos

    Draining pool and noticed this staining showing up - i looked back at older photos and it wasn't there when we opened it. Any ideas? Hardness seems low but unclear what would cause this. I can start a seperate thread if that's helpful.