Recent content by Navigator6850

Thanks for the tips. And yep, ran the salt test with the standard from the kit. See a couple of posts above where I discussed it further. Ultimately this gave me a revised factor of 160 (compared to the suggested 200 factor in the kit instructions).

Appreciate the advice thanks. And yes, to your earlier post I also had a suspicion it was the sensor.

Fortunately no extra salt has gone in! So you would recommend replacing some water in lieu of letting it come back itself over time?

A further progress update. I've managed to get the cell out. The plates themselves I think look ok. In general black and shiny, possibly a tiny amount of build-up just beginning to form on the tips of the plates (outlet end), but I feel this is fairly minor. Possibly some build up to the plastic...

Hey mate, 10,080 came from the salt test as part of the Clear Choice Labs Kit. Total of 63 drops until the solution changed colour from the milky yellow to milky red. Based on the instructions (multiply drops by 200) this would actually equate to 12,600ppm (+-200ppm), however performing the...

So I've re-run the full suite of tests this morning and got much more useful results shown below (not sure what I did wrong the first time with the FC test but below result seems correct). However salt level now appears to be the big issue.... FC = 2.5 CC = 0 pH = 7.6 TA = 20 CH = 125 CYA = <30...