Recent content by MyCaliPool

I mapped the water flow out and added plastic labels to all the pipes for future reference.

Thanks for all the help friends. I figured it out!! I had a solar panel replaced a month ago. The worker must have switched one of the auto valves from 2 (good) to 1 (bad). So for the last month whenever the Solar was running it actually was not. And vice versa. So when Pool Mode activates...

Thanks Jim. No, nothing has been added to the pool. I ran the pool last night with the filters removed. I see no change in filter pressure and no increase in flow (with the cartridges removed). It looks like I have a very similar systems as yours. I've turned off solar heating to isolate that...

Thanks guys. I topped off the water. I could not find any debris in pump impeller. I replaced the shaft seal on it 3 years ago. The pump is 9 years old. The filters I cleaned last night again and they look in good shape. Cartridge filters are prob 5-6 years old. The VS pump is programmed to...

Hi friends. My water flow has been cut in half recently. I can see it on my waterfall from spa and the skimmer isn't working well. 1. I cleaned the 4 cartridge filters but no improvement. So I removed the filters completely to test if they were the issue and NO improvement. With no filters it...

Turns out I did my salt test wrong. I used the 25ml mark and not the 10ml. I took my sample to the pool store and it was 2000ppm. I retested at home and I got the same. It was all my fault. The light was correct and I just need to add more salt. Sorry for the stupid post guys! I know better! I...

Thanks, everyone! I finally got to talk to them. They are confused about why it is reading low salt too. They said it should operate ok at 63F water temp. I am going to go get an independent salt test to confirm 4000ppm. But the Taylor k-1766 test kit has been very accurate for this in the...

Brand new IC40 installed. The red low salt light won't go away. What am I doing wrong? Salt level has been tested with a taylor salt test kit and is 4,000 PPM Water temp is 63F (the manual says 57F and below it is too cold to work) It is set at 90% output on my EasyTouch Panel and enabled...