You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
-
M
So I took it all apart again and the original Made in USA oem bearings were smooth as butter. I could spin the axle by hand and it would...
-
M
Then I will replace the axle and bearings too. However, I did discover that the paddle wheel jet was clogged. I took the cover off and...
-
M
So I installed new wheels and a new small wheel. The gears all mesh. I took off the turbine cover and ran the pump and confirmed it had...
-
M
The axle is in good condition, and spins freely. The wheel on the single wheel side was like 90% fine. The two large wheels and the...
-
M
Give the paddle wheel a spin. Is it smooth? If not, replace the bearings and while you are at it replace all the bearings (8) in all the...
-
M
Yes I have removed the jets and cleared them out, and the little inline filter.
I’ll have to dive deeper in and inspect the turbine then.
-
M
My sweep has been functioning very poorly for a few months, and finally not working at all. I took the wheels off to find the inner...
-
Loading…
-
Loading…
-
Loading…
Like.
Give the paddle wheel a spin. Is it smooth? If not, replace the bearings and while you are at it replace all the bearings (8) in all the...