Recent content by MaverickFL

Have no experience with those lights, so couldn't tell you. Can they be opened/serviced like the Pentair? The DigUno/ESP32/WLED combination works with dozens of different LED drivers, so probably you could find something that will work. If the TREO is nicheless you will need something...

I've been running this configuration for more than 500 hours now, so I'm confident to share it with the community as a possible solution to others who have had their intellibrite light die on them only to find out that replacing the poorly designed LED driver board is almost as much as replacing...

Perhaps the final update for this thread. Although I cant say why, or 100% for certain, the screenlogic adapters seem to have somehow been causing the problem. I disconnected the screenlogic for a few days and did not notice any phantom starts on the pump. Then I shut everything down on the...

When using the PoolMonitor app from an external browswer like Edge, the default setttings are too sleep unused tabs to conserve resources, there is setting under settings, "system and performance" / "Never put these sites to sleep" to prevent certain sites from sleeping, this will keep the log...

Thanks for all the suggestions guys. Trying to work through this methodically since as noted it is a complicated issue. I think the logs could hold some clues but Pentair basically dismisses the pool-monitor tool/logs and refuses to review the data. Anyway, last night I disconnected the...

I have never heard of anyone lubing their cables or connectors, thats a new one, but, I have double and triple checked all the wiring and connectors several times and although I could replace all the cables, nothing is pointing to that as a leading cause. Why would the cables cause problems...

I'm starting to think possibly this must have something to do with the screenlogic maybe, its the only component left that wasn't replaced. Any thoughts anyone?

Update. Some good people still work at Pentair. I got in touch with one of my regional service managers (Rolando) and got some movement finally. They came out and swapped the motherboards on both the ET and the Intellifo 3. Unfortunately, this did not fix the issue :brickwall: . I'm...

Hey Tom, Nothing yet. I sent the log file off to Pentair this morning to see what they can figure out. What youre saying make sense, I'm learning as I go. 21633 is just a status message. I don't see where the OCP actually told it to turn on. I see a lot of message '6'';s (set...

I finally captured one of the random starts in the message monitor, I have no idea how to read it though to see what it is telling the pump, but you can see in the log it causes a state change at ID: 21633 where there is no program set to run. This happened four minutes after the last program...

Allright well, I have figured out from the nice little wiki where to find the message monitor. It seems that since I have a pump but have disconnected it, the ET is constantly trying to find it with the action '4' and action '7' messages. But in the capture attached I do see the action '1'...