Recent content by mattdirks

I did decide to shut everything down. I put a camera in the pool room before I left...but for some reason it failed to connect to my WiFi...so I am flying blind for a couple of months. I do have someone coming in once a week to flush toilets, so she will let me know if there is some kind of...

The pump sits at deck level, so I would say 6-8" above the surface of the water. I too didn't think that it should lose prime...and I seem to have small air bubbles coming out of the first return jet...so it makes me think the leak is there. I just had all of the plumbing redone, but they...

Wouldn't want to burden them with that. I was the sucker to buy a house with a pool. 😁

I read a few other posts about this...I think a check valve in between the filter and pump should remedy the situation. Curious about the concern of this issue...am I overlooking something? If I shut everything down, I can get things started back up without issues once I return.

Ok...thanks for the advice! Will raise fc and cross my fingers (unfortunately no cover... didn't seem necessary on indoor pool...but may regret that decision). Hiring someone to come around and check an indoor pool once a week is almost impossible around here. No one seems to want to work. :(

We rarely have a loss of power, and if we do it is usually very temporary (1-2 hours max). If that happens, the system will reset and resume once the power returns. Regarding my filter, I rarely have to backwash...being indoors, there is hardly anything to dirty the filter in the pool...

I did a bit of searching on the forums, but may have missed my answer... I have an indoor SWG pool that I just had completely remodeled. Everything has been working well...pH and ORP are regulated. I will be leaving for several months and am curious as to what I should do in order to prevent...

Was able to get everything wired up properly over the weekend. Thank you for the support and advice! Very much appreciated!

Ordered flow sensor and will have electrician correct pump electrical wiring. Thanks for the help! Will post back with success. :)

Ok...making some progress...I was able to get the pump recognized...but when I was running through the configuration wizard, I had to first turn on the HVR1 for the pump, and then select the HUA that popped in for the pump. When I finished the configuration, I exited from Service Mode and tried...

Ok...let me try and reverse those...thanks Chris.

No dice...HUA still not showing up. Left the pump off for 30 minutes for good measure. Here are latest pics...

Ok...let me try and rewire again to see if I can get it to come up. Will post pics shortly.

Here are pics of the wiring connections...

Yes, the speed was set for 2700 RPM. I went back to mess around with it again, and noticed that the HUA was missing when I edited the pump configuration. I tried deleting the entire setup and starting over, but now cannot seem to get the pump's HUA to show up again. I have turned everything...