Recent content by markfj

Thanks...haven't checked them in awhile. Will check them tomorrow. Thanks again!

It is a pentair whisperflo WS-4 pump. The impellor does not appear to be clogged. The impellor does spin...I have not been able find any air leaks. Skimmer is not stuck.

Hi, It has been awhile, but looking for some guidance. Have a pcc2000 system. The skimmer/in floor system has a hayward ws-4 and 1.5hp sq1152 motor. The pump will not prime...I have replaced both the capacitors (start & run), I cannot find any blockages, clogs or air leaks. The motor shaft is...

Thanks...I will give it a try...do you know does it save the programming or will I need to re program??

Hi...installed a V Green 270 pump about 5 months ago based on interactions here on Trouble Free Pool and it was an excellent choice. My problem is...I went out a couple days ago to make an adjustment and found that the screen/interface is blank. It is lit up, but nothing is on the screen. There...

Aaaah...thanks cowboy...appreciate it...going nuts trying to figure that out

Thanks James!...really did not want to pull it apart again....so what rpm and time do you think I should run it, based on the info I provided???

My BAD...you are correct Whisperflo

So I have an intellifo WFE-6 pump...inyo told me that the vgreen 270 would be the right size motor...never said anything about the changing out the impeller...should I have done so...and I apologize but some of this thread is above me...apologize for my ignorance... Thanks again for help/guidance!

Is there a way to shut off schedule 2 & 3 on a vgreen 270 variable motor?? Thanks

Any idea how to prime/start it the 1st time

Thanks...MUCH APPRECIATED!

I just swapped out an intelliflo motor with a vgreen 2.7 motor. Would like to know the best rpm and amount of time to set it to run at: Location: Phoenix suburb 15-18000 gal pebbletec 2 pumps Filter - new vgreen 2.7 In floor clean/waterfall: 1 hp intelliflo Pentair Clean & Pure Cartridge 420 Had...

Thanks ajw22... -Any other alternative VS pumps? I have seen a brand...Harris i think? -Also, any recommendations on HP for the filter pump? Jimrahbe comments on running a 3 HP at 1200 rpm...i was thinking like 1.5, 1.65hp, but DO NOT want to undersize it -Also any recommendations on the IFCS...

The timer is not reflective...usually run anywhere from 6-8 hours and costs a large fortune...