Recent content by kriskris

I just installed 2 speed pump and intellipro 60 in my pool. It is my first SWG and it only will run at higher speed on the pump. What is the best way to do it? Should I run SWG continuously for few hours at a time or is it better to change the speed few times a day to get more of an equal...

I think you are right. The diagram shows only line connection at L1 and L2 and ground at green. It is a 2Green AO Smith motor with internal timer built in. Diagram does not show any connection at 4. I have not tried to connect it yet because I just discovered that my existing motor is 115 and I...

Thank you Richard320 and Roadking00! your help is much appreciated.

How should I wire this motor? It is 2 speed OAsmith with timer 3/4 hp. I understand the ground wire is connected to green screw. How do I connect remaining two wires?

Do I understand correctly? If i do not have a heater nor tablet feeder I do not need check valve?

I am planning on adding IC 60 to my set up. I will have a new 2 speed motor, pool vacuum and no heater. Do I need check valve or vertical bypass? Thanks, Kris.

Thank you.

I am planning on updating my equipment. My pooI gets a lot of tree and yard debris. I want to get 3/4 HP 1.65 service factor full rated AO Smith dual speed pump, Pantaire quad DE 100 filter, large leaf cannister for white shark vacuum cleaner and Intellichlor IC 60. I also want to move my...

Thanks for the link! I do not see any copper. I guess it is post 1998. Great forum. Really appreciate all your help. Kris

Thank you.

Yes I am. I just opened wet and but I do not know how to get part #10 pulled of the shaft?

What is your recommendation Jason? I have unscreened pool in FL and I get a lot of debris from surrounding trees. Which filter style would be better?

Thanks. So I guess I have to disassemble my pump to know for sure?

Is than backwashing enough to clean grid style filter without disassembling entire filter?