Recent content by kenh

  1. K

    Need some ideas/Gunite pool leak

    So I noticed I had a leak sometime last season. After several weeks of analyzing the leak, I know several things. The leak is not from my plumbing as I plugged everything, and it still leaks, including drains. Pool leaks the same running/off. The leak stops about a 1/2 above the bottom of the...
  2. K

    Pureline PL7700

    Thank you.
  3. K

    Pureline PL7700

    Thanks, I’ll try that. The manual doesn’t address the reversing polarity or the cleaning. It only states that the cell is self cleaning.
  4. K

    Pureline PL7700

    Does anyone have any experience with Pureline?? Installed the above unit the other day, and the amp reading on the diagnostic screen reads -4.64 amps, a negative number. The actual number is within the range recommended by the manufacturer, but it is negative. The system says it producing, so...
  5. K

    HELP!! At wits end....

    I would have still been floundering if you didn't post the correct electrical hookup info.
  6. K

    HELP!! At wits end....

    Problem solved.........................drumroll please..................................the wrong pump was chosen in the IAqualink interface. Yes, it was that simple. 4 hours of frustration, and an extremely easy fix. Connecting the pump to the right power supply was the first step. Thanks...
  7. K

    HELP!! At wits end....

    The manual states, with the RS8, to have all the pump switches in the off position. It then continues on to state that switches 3 and 4 dictate the pump address, and could be a different combination. How is the pump address matched to the aqualink power center?? Also, the new bezel which came...
  8. K

    HELP!! At wits end....

    Awesome, a step in the right direction. The Jandy pump WAS wired to the relay. I direct wired it to an open breaker. Now, the Jandy pump controller works when in "auto" mode, but the pump will not work through the rs8 system. For some reason, the rs8 is not communicating with the new pump. My...
  9. K

    HELP!! At wits end....

    OK, so I swapped out my 10 year old Jandy HP Plus pump, with the new VS-Flo Pro. Everything went well, plumbing, electrical, etc. I also have a Jandy RS-8 system, which I upgraded to the new IAqualink, which required the new PCB. All wiring was hooked from old to new exactly. Here is the issue...