Recent content by johnto

Would this one work too? https://www.amazon.ca/Hayward-GLX-PCB-RITE-Replacement-Goldline-Generators/dp/B002MNJ1TE

Hey everyone, ok so I am going to replace the main board. Does anyone know exactly which one I need to order? I just want to make sure that I do not get the wrong one. Please see attached photos for the board (you can see the burned out area on the top right).

Yes I can jiggle them and force the unit back on and the swg will work for 10-15 sec then the display will turn off again.

Hey everyone, My Aqua Right Gold Line SWG display will work for 10-15 seconds then I hear a click and the display will cut out and the panel will not show anything. I have done some research on the forums and have noted that usually a Thermistor will fix this issue. I have ordered a new...

Yes I will be replacing the uniterm governor and I bought the internal bypass to replace as well. For the internal bypass it came with two springs a silver one and a red one. Which one do I use for my 406A? I specifically have the P-406A EX-X Curpo Nickel 399k btu heater for a saltwater pool.

Just another thing. I took the front panel off of the unit and watched the heater for around 10-15 minutes. It would heat up fine and then it would throw the High Limit 2 error and then quickly shut off. It would then start back on by itself and start heating again until after 10-15 more...

Hi Everyone, I have been having some trouble with my pool heater for the past few weeks and wanted some advise. I currently have a Raypak 406a 399k BTU salt water pool heater. I was running my pool equipment when I noticed low flow from the jets one day. I then started to notice some silver...

Hi everyone, This is my first post happy to be here! We opened our pool this year and in our deep end there is a large white patch which was not here last year. I tried to scrub it out with a brush but I cannot remove it and im slightly freaking out because we just changed our liner to a new...