Recent content by joeg679

Ok. Thanks.

Thanks. I went to a home depot and they don't have it and neither does the pool supply place. I called Hayward and they said they will get back to me in a week. I called the company that manufactures it, which is on the old wire and they only sell it by 1,000 feet. They said to try an...

I ordered a new gas temp unit (pictured). It comes with the orange wire shown, which is good because mine is rusted. I would like to order some more of that wire because it connects other components in the heater and I'd like to replace any old wiring. Is this sole on Amazon, along with the...

I replaced the filter cartridge and the water coming out of the jet is much stronger now, but I still get lo code and I did unplug the wires and plugged them back in.

Are you referring to the pipes that go into and come out of the heater? I’ve done that already. Or are you referring to one of the electrical components?

It reads zero when off. How do you reset the connector? Thank you!

I'm not in front of it to check to see if it goes to zero when off. When it's on, it's around 15. I don't think it has a bypass - I'd have to disconnect it and re-route it, but I should install a bypass. Also, it's a Sta-Rite pool filter, not a Pentair. Here are some pics

I didn’t make any adjustments to the switch. I just screwed it in, out of the box. The filter and heater and on the ground about 4 feet below the water level.

Sorry. Above ground. Pentair cartridge filter.

Sorry. I have a hayward 150fdn heater and the pump is a hayward power-flo-lx

Yes, I did.

Ok. Thanks. The pressure is the same as it usually is. Is there some kind of pump mechanism in the heater that would cause this?