Recent content by jmdeacon

I have a pentair valve with a compool actuator. The toggle switches allow it to either be off at the main drain or the spa suction but I want to be off at the pump so I can disconnect it. I can't figure out how to do that manually. Here is a picture of it.

I have my Easy Touch controller set to run the pump from 6 am to 4 pm. The pump turns on and off when it is supposed to. However, the two times I shut the power off to the system to make some wiring changes, when I repower it, I have to push the pool button to turn on the pump even if it is...

Do I use 2 wires or 4 wires to connect them? I found one manual that made it look like just the data wires and another that said all 4. Thanks

I upgraded my Compool to Easy Touch. I already have an IC40 connected through the power center and it turns on and off properly when the pump is turned on and off. Am I able to connect the power center to the Easy Touch com port and have the Easy Touch adjust chlorination based on settings in...

Thanks for the clarification. I don't need to know the flow but since I saw it listed as "--", it made me wonder if I should have picked vsf. I will leave it as it is.

I have upgraded a Compool to the Easy Touch so I can save money on electricity with a variable speed pump. I have the Pentair Whisperflo VST. When initially setting up the Easy Touch for the pump, there was no choice for VST. There was a choice for VS and for VSF. Which one am I supposed to use...