Recent content by jmack549

I have a recent development where air is getting into the pump housing somehow and pushing out to the spa. I can't tell if it's coming in through the pump or elsewhere. So far I have tried different pump lids (with different o-rings), and still the problem persists. I know the most obvious...

You're a legend, thank you.

Sorry but I've been driving myself nuts for over a week on this. I have a pump that is attached with a metal compression ring, and I noticed a leak at the bottom. First thing I was told to do was replace the o-ring, but for the life of me I can't figure out what it is that I need. Here is a...

I have a Raypak with an electronic ignitor, which appears to suddenly be non-functional. It no longer buzzes when starting, and after 30 seconds or so just gives the "ignition failure" error. I have a company coming out next week to look at it, but in the meantime I was wondering if it's...

Good idea! It's now raining here so I'm unable to test at the moment, but I have a voltmeter and will check when able.

Thanks, that makes sense! Strangely nothing is tripping, even with all equipment turned on, so unsure what's going on. I'll open it tomorrow, see what I can find, and likely have a professional out next week.

Thanks for the response! I have a decent understanding of electrical, but will still be having someone out next week if I can’t find anything obvious, it’s not worth the risk to me. As for the clicking, it’s actually always done that, for every item in the panel. It does it for the lights, the...

I have two pumps, one for the pool and the other for the hot tub. I was in the pool earlier and the pool pump was running, and my wife asked for me to heat the pool. I went to turn the heater on, but it wouldn't spark. This has been happening for about a week now, but last weekend resetting the...

Hey all, I have an older Aqua Rite that is power cycling whenever I connect a cell. I have tested it with several T15 cells and when they are plugged in but not connected (no waterflow), the board behaves normally and the voltage stays at a consistent ~22. When I plumb in the cell and run it, it...

I think, unfortunately, based on the below I'll have to replace the whole thing. Good to know about the OneTouch though!

Gotcha, thanks for the info. I realize I could have shopped around and found a newer board but I was sort of in a bind. Live and learn. Looks like I got an RS8. Would this be a suitable replacement...

Update on this, I had my new board installed this week and it's working great. As a wrench thrown into things, they installed the Rev A board and found it couldn't control the actuators. I guess maybe it was RMA'd? In any event, I bought a used Rev MMM from them for $400. My thought is that I'll...