Jimrahbe's latest activity
-
Jimrahbe replied to the thread IntelliCenter Program just SWG.OTC, Your SWCG gets its power from the Pump/Filter relay.. This relay only closes when in the pool mode or the spa mode. If you run a... -
the board has a 8 wire plug, 2 for each of the relays, so I won't be able to pull it off there. That's why I wanted to secure the hot...
-
Jimrahbe replied to the thread New Pool, Easy Touch questions.Jda, You can run the pool at a low RPM, and things will still work.. You can't really run the spa at a low RPM.. This ok as you are...
-
Jimrahbe replied to the thread shocking salt water pool.hc, I suggest that you find a pool store that has a clue what they are talking about.. :mrgreen: Actually, I suggest that you...
-
If you follow TFP methods, there is no reason to shock or super-chlorinate your pool. What test kit are you using? Post a full set of...
-
There are very few reasons to step foot in a pool store, and zero reasons to ever take advice from someone who works there. If you are...
-
Jimrahbe replied to the thread AC Wire Removal.raj, Just unplug the little 2-wire cable that comes from the relay and plugs into the main card.. Just unplug it at the main card...
-
Jimrahbe replied to the thread Dolphin Diagnostics (2008) wiring repair help..G, There is no "possibly" to it. That resistor is toast!!! :mrgreen: Great job... :goodjob: Thanks, Jim R.
-
Jimrahbe replied to the thread I am not crying yet.Mc, I don't know much about above ground pools, but basically your pump is gravity fed. Water should just flow out of the pool and...
-
Jimrahbe replied to the thread Suction Side Air Leak at Base of Skimmer.Jenn, Great job so far... :goodjob: For some reason I was thinking that the PCV was glued into the bottom of the skimmer. Glad I...
-
Jimrahbe replied to the thread To drain or treat.13, If the cost of chlorine is going to be more than the cost of the water, then it only makes sense to drain and start over. Thanks...
-
Jimrahbe replied to the thread Suntouch panel and 2 speed pump.Go in and un-assign all the circuits you set up as "High Speed".. In theory the high speed relay should then not turn on.. Unless a...
-
Jimrahbe replied to the thread Pentair IC60 - Transfer guts to new housing?.Steve, Is the crack in the unions or in the cell itself??? Jim R.
-
Jimrahbe replied to the thread New Pool, Easy Touch questions.jda, You should use the speeds that work for you. I do not have a heater and 1200 works well for me.. If I had a heater, I'd have...
-
Jimrahbe replied to the thread Need to replace my Intermatic pool timer switch.The one in my post is plastic and listed as weatherproof.. I like the plastic better, but only assume it to be code compliant...
