Recent content by jholbey

OkI have a friend that is a electrician I will check with him... thanks

Thanks I will contact Rapak about the 208volts... I appreciate your help

Thanks JamesW... I will get the single double pole 140amp breaker instead of the 2 single 70amp breakers

This may be why I’m getting 208volts and not 220-240 volts

Thanks JamesW... That is some good info on 3-phase panels... I will double check what I have done and make adjustments. Thank you so much

The unit is supposed to show low or high voltage problems. It does not show voltage problems. I do think this should work on 208volts but it will draw more amps.The unit is not shutting down it never comes on for heat.

Thanks for your reply thanks for your reply and questions... I do have 1-60amp breaker in my sub panel for this heater. I have 2-70amp breakers out of my main panel going to my sub panel because that is what the manufacturer wanted to the sub panel.I am sure the electrical is correct on this.I...

That’s what I’m thinking because I can’t set a temperature on it and it seems to be faulty.Thanks again

Thanks for your reply... I know that my main panel that supplies my sub panel is 3-phase. This is a church and we have 3-120volt lines coming in the main 200amp panel which feeds my 60amp sub panel 208volts. My sub panel is not 3-phase I have 2-120volt lines coming in. I hope this helps in...

Thanks again for your response... I have 208volts at the heater I measured it so I know I have both 120volts.I will get you a pic of both panels but my main panel is 3-phase 200amp 90ft away from my new install sub panel to spa 60amp double breaker. I’m showing 120 on each leg of sub panel and...