Recent content by Jaymike84

I just noticed mine starting to do this after 3-4 years of use. How’s yours holding up?

Thanks for the reply. Yes I saw those was just seeing if they were worth the 135 dollars or not. Reason for asking is the reviews I’m seeing is those leak quite a bit and they don’t function properly as a lot of negative reviews on them so seeing if the drilling of the hole was sufficient or...

I am going to 2 inch and wanting to Replumbing it because when installed they used ball valves which after 3 years are already getting difficult to turn. I have heard some put 2 way valves from the intake to the solar pool heater and going back to the pool but not sure I need because of check...

I was told a good idea to have one after the filter so it doesn’t go back through the filter as well.

The solar pool heater I’m going to install for a 2 inch header so will be using 2 inch pipe. I currently have 1.5 inch piping. How easy and what do I need to attach to my filter and the return line. I’ve been seeing ways to remove the old pvc and reuse it safely without damaging the return piece...

But that’s just as good as any of them? Because that’s the one I bought

Ok. It will be bottom right to top left back to pool. I’ve attached images of the tripe of VRV I have that needs to be piped in. Will that work?

Thank you for the help. I was told to put the vacuum relief valve at the top opposite the intake ( return line). Will that work? and definitely will make sure there is a check valve and manual shut off. Thanks for the help

I am wanting to install solar pool heater That is below grade of my pool. My question for it is where do I install the vacuum pressure valve and what’s the best way to do it to make sure the water empties back into the pool when I close off my valves. Or is this even possible because it’s below...