Recent content by Jamesg0824

Bama I will try to disconnect the spa remote tonight and see if that solves the problem. Then if that doesn't help I will try to address the dip switch. I was wondering if either of these made sense or if there is something else I can try? Thank you

I have a Jandy RS6 controller and a Jandy Aqualink 6614/6615 Outside PCB Box. I have had numerous issues over the last 2 - 3 months. Here is a summary: 1. Pool Pump would not turn off - I replaced the relay and this problem was solved. 2. Cleaner Pump would turn on intermittently, even when...

I recently replaced the control board. The outside controller is a Jandy/Aqualink 6613/6614. Tonight I am going to clear out all programming information and re-program the equipment. I do have control buttons mounted in the spa but not a remote. I have program control board installed in my...

I am have issues with a Polaris 280 starting intermittently. The cleaner starts when it is programmed to, and runs the programmed time. But it can start up again later in the day or evening. I have re-programmed my equipment and even replaced my controller board. The problem still exists...

I am going to do the drain/refill this weekend. I was going to drain at least half of the pool, probably a bit more. So after I refill I plan to add bleach to raise the chlorine level, run for about 4 hours then re-test the water.

My pool is 18,750 gallons. Inground. Pebbletec bottom. I live in Houston Texas. Right now the water is clear but I am worried about algae since my chlorine is low. The water costs in our area are not too high. I was under the impression that the only way to lower the CYA was to perform a...

I moved into my current house in 2008 and inherited an chlorine pool. I have been having trouble keeping the chlorine levels high enough so I had my water tested. Sure enough, my CYA is over 100. So I am going to drain 1/3 to 1/2 my pool and start over. However I want to use the BBB method...