Recent content by ideal2545

Hey all, looking to buy an outdoor container and get this MA out of my garage, im debating buying a bigger plastic container but I know im limited on what I can store with the MA as it off gasses, do you guys think things like charcoal would be fine to store in the same container, possibly...

Ok! I’ll give that a shot instead of this direct to the board hookup

Here’s a pic:

I made an assumption here that I was using the fireman’s switch, I just double checked and it’s going direct to the board, I did a check there and it’s only 5V coming from the board direct

Ya I checked the voltage between the two from common to spa and it’s 5V and and then i checked against ground and it’s also 5V, the buttons are operating still, I’m wondering if I flip the jumper to disable the buttons if it will maybe fix this

Hi all, troubleshooting an issue where my max-e-therm won’t turn on via my Jandy controller, I was doing some voltage checks on the two wires coming out of the Max-e-therm and going into the controller and it’s only getting 5v, it’s my understanding that it should be 24v, has anyone seen this...

Has anyone managed to get the official B Value from jandy or hayward for their 10k thermistors?

Thanks a lot, this is extremely extremely helpful

Hi All, I'm currently building a custom pool controller using some relays, and I'm trying to figure out the best approach to the Max-E-Therm 400 that I have. I'm reading the documentation and I can do either a 2 wire or 3 wire install. The 2 wire requires the use of the firemans switch (from...

Hi All, I currently have a Jandy RS4 and I'd like to be able to control the pump speed on my Intelliflo and be able to control it all from my phone. I know there is a "Jandy iAqualink 2.0" upgrade of some sort but I'm not sure if that only adds wifi or if it will also let me be able to control...

Nothing happens when pushing those buttons, at all, just nothing, like its totally dead. I do have a remote control to a Jandy RS4, I tried turning it on through there, and also disconnecting the two lead wire to the Jandy and trying to turn it on manually with no luck. I definetly can post...

Hey All, Hoping for some guidance, my Max-E-Therm will not turn on, I took it apart and besides being massively dirty the wires dont look chewed through. I flipped over the top and when the heater gets power about 5 led lights turn red simultaneously and then turn off. The display on the top...

Hi Guys, Hoping someone with a Jandy RS4 could give me a hand, I want to leave the pool pump always on as I'm using the built in timer on my Intelliflo but I can't figure out how to do this, I'm trying to program a schedule but I can't say turn on at midnight, and never turn off. Has anyone...

Hi All, I'm still a bit of a noob at reading the CYA chem test but I think that in my SWG pool my CYA is sitting between 85-90. I know that the recommended level is 70-80. Is this discrepancy enough to worry about or should I dump water? I suppose I could try to maintain a slightly higher FC...