Recent content by ianwelch001

I have the Dreame z1 pro and they also dont have a super fine filter so I was able to get a skimmer sock and rig it in there so its been catching pollen and fine silt

I know this is over 4 years old but my cc plus does the same thing. Its 4 years old. I replaced the power cord at 2 years. I checked that and its fine. Getting good voltage at the motor. Which motor did you have to replace?

That sucks. I havent had that much bad luck. They told me theres supposed to be a firmware update tomorrow. Not sure what its going to fix though

Weird. Mine also toggles off but the map still shows. My z1 pro is very good about going around the main drains. There are definitely some bugs to work out which I've been talking to them about. All my issues are software related so hoping updates fix them.

I also couldn't get my maps to show up. You have to go to lab mode then map display

It randomly stops on 1 section of my pool and I have to fet it with the hook and move it. It also was set on walls only today and started doing the floor. Then started spinning in place for 2 minutes before I grabbed it. I think theres some software bugs they need to figure out

Ran my z1 pro yesterday and thought it was doing good until I checked my pool. As you can see it doesnt clean everywhere. It left a few streaks of silt on the bottom and then this large patch. It must not have even ran this section over once.

Hope so. Only real drawback ive noticed so far is when doing floor only it stays about 8 inches off the wall the whole time so it doesnt get things where the wall and floor meet. When i do a standard clean (floor, wall, waterline) it gets the edges and corners. Since my pool is only 6 feet deep...

I just started using mine today and so far its been great. Mapped the pool No problem. Didn't get stuck in my main drains at all which my Nautulus CC plus always did. Also didn't get stuck on my buddy seats which my old robot did too.

Have to love clean straight lines with a vacuum after opening. This was the cleanest my pool has ever been opening it after winter. No green algea l, just dirt and sand and some leaves and worms

Last year I stopped using my frog system and went to liquid chlorine only. Pool looked great, and just opened it and there was no algea in it. For those who went from a frog to liquid, did you leave the frog cycler in or remove it and add a straight piece of PVC. I just noticed a small drip...