Recent content by Hayward Pool

Thank you for sharing your feedback. I’d like to hear more about this and offer my assistance. You can reach me directly at [email protected].

How Hayward will react is how the motor failed. If a leaking seal left unattended this would be water damage. Private message me if you want to talk.

Not sure of the problem, you can call customer service also at 908-355 7995 to speak with a tech - - - Updated - - - SX180LA is the kit for this filter. Cap and oring.

3700GPH is about 60 gpm. Not sure what HP model pump you have, but some may be able to support.

I have the same question about power. Normally when the heater lights there is power. Shutting down after a minute could be no flame recognition. You should have a code like IF?

If you switched cells and the unit is working fine, my guess is the cell needs to be replaced. I sent you a private message to talk over the phone.

Hi, the check valve is very necessary for tablet feeders but not salt systems. Hayward's and most in the market place that are hooked up correctly do not need the check valve.

The LO code will also come one when the pump shuts off and the pressure switch opens, this is normal. If the LO is lit when the pump is on one of the switches (pressure, High limit (2) or if indoors the vent pressure switch) is open. Test each one. The blower continually running could be a...

This is Hayward, I fully agree with Mass985.

There is a way for the two to talk to each other but it is a lot of wiring. It is shown in the manual. I will help you if possible. I sent you a private message.

I noticed that you have a caretaker system which means you have pop up heads in the bottom of the pool for cleaning. These sometimes cause higher than what we call normal pressures.

If you powered down and up did a error code show up. I PM'd you with Hayward Contact info.

For information make sure you get the flex style unit. It has a flex vanes on the turbine. Alows for more debris to pass. This is available on all suction cleaners. Just ask. It is called V-Flex.

I am a little concerned where the pricing is coming from as I went on Amazon and saw a GLX FLO RP for $51.09 http://smile.amazon.com/GLX-FLO-RP-Assembly-Replacement-Chlorine-Generators/dp/B0030E3US2/ref=sr_1_1_sspa?ie=UTF8&qid=1509549213&sr=8-1-spons&keywords=glx+flo+rp&psc=1

The key is going to be the voltage at the light. If you have 12 volts at the transformer and the light cord is over 50' you may have a transformer problem.