Recent content by harpfamily

I have a Dolphin T35 that will only move a couple of feet in each direction and struggles to stand up and climb the wall. I’ve checked the voltage on the controller and also the cable. Any ideas? Also, any recommendations for a replacement robot? Thanks!

No, it has never done this until recently.

I have a Intellibrite 5G 120v Color LED pool light. The issue I have is when I turn it on it flickers on and off 4-5 times and then works normal after that. Any ideas? Thanks

Are you sure the flow switch is turned to the right direction when installed? It has an arrow on the top of it that shows which way the water should flow through it to make the no flow light go out.

A.O. Smith 1 HP Full Rate Two Speed Motor W/ Timer - Round Flange (B975T,B2975T) - INYOPools.com I'm considering replacing my 1 HP Super Pump motor with this. Any thoughts? Thanks

pH-7.2 FC-2 CC-0 TA-110-120 CH-70-80 CYA-35-40, have added 8lbs since opening when reading was zero. Any advice? Thanks

Having a problem keeping algae away. I keep FC between 4-6 and CYA is 60-80. We have had some rain and haven't swam in 4-5 days and I keep it covered with a solar cover. When I take the cover off you can see algae in the corners and creases of the deep end and also some on the deep end floor. I...

Can't you achieve the same thing by using non-chlorine shock to destroy the chloramines?

Yes, messing with the calculator now. Seems pretty straight forward. Thanks for all the suggestions!

I used 8 pounds on pool store recommendation, haven't played much with the calculator to be comfortable with using it yet. Water looks nice and clear!

I've been a lurker for years but never really embraced the BBB method. Looking to do this more on my own without pool store help. Looking for support from the forum.

Water Temp 75 FC 2 CC 0 TA 80 CH 70 CYA 20-30 added eight pounds 3-4 days ago, finally starting to register. pH 6.8 Thanks!

My CYA reading shows zero. I poured 5 lbs in a sock yesterday and it dissolved, shouldn't I have some sort of reading by now? Thanks

FC-.5 CC-.5 TC-1 pH-7.2 TA-100 CH-80 CYA-0 SALT-3100 Thanks

Have a SWG and the ladder and railing anchors are corroded. They were made out of aluminum and I want to replace them with bronze. Any tips on getting the old ones out or any other info? Thanks