Recent content by hagotime

I've had a brown stain develop over the winter that I could not managed to brush away at all. It has covered a fairly large area. The pool is finally large enough to get in so I went under with goggled to look at it. The area makes a slight divot into the marcite and it really just appears...

Pool Clown, I've got my pump in a running. Right now I have the Pentair timer set to 6:05-6:55 for 2800RPM overlapping the tabs on the Compool from 615-645 for the Booster Pump. I've noticed the intelliflo keeps time whereas the compool will stop spinning with a power outage. Theortically I...

Placed my order yesterday morning and it was already here, guessing Amazon's Florida warehouses are where these things are at.... Removal of the old pump was easy just undoing the slip sockets. However two issues...hopefully solved! 1. I was confused by the sockets to the new Pentair unit...

I'm complete tracking the extra RPMs for the booster pump and ensuring the time sync. My question is what is the potential damage if this gets out of sync? Will it just be low pressure to the cleaner or will it potentially overheat of cause damage? Also, what would you recommend for run times...

Jim, Thanks for the help on this. My local pool place seemed certain they could hook into my Compool though after reading some DIY'ers seems much cheaper to just wire and program myself. I'll just make sure I watch the timer and check after power outages.

Hi, I just purchased an Intelliflo 011018 to replace my Hayward single speed unit that just failed. Before I started I was wondering if I could get some advice on ensuring I get the programming correct. The unit was a 1.5 HP pump with 2 inch piping. It runs to an older Compool control panel...