Recent content by Glen Innes

Thanks James - The aux ground path (as set out in the fenwal kit) i had put in earlier. So i reckon it must have been these little bindi eyes swirling around in the mixer. Have you ever heard of such a thing? Or maybe she,s a heater that needed a bit of tlc on every level to come back to sync...

Run out of rooom so , then found this, a few bindis and foot ticklers (see pic ) could these little bindi eyes sucked in by the blower make a flame drop?? Cleaned the pipe , it looked spick and span. So put the whole show back together and bingo!! She fired up and stayed on. Fluck? Shut her down...

Well swamp rat ,8James and all, I went to town and bought a trms 6000 multi meter to confirm the sensing , and yep it read a a few microampers when work up and lite then boom it was out as the flame dropped out, gas stoped. So reconfirmed igniter yep good so I bit the bullet and took the whole...

G'day swamprat and thanks for the info, the gas valve is like the one in fig 35. last post attached photo no1 shows a top veiw of the valve and low side test screw in top right hand cnr. As i have been getting a reading from fc+- of vdc except for yesterday (maybe the age of my Multi) when i...

Any ideas ?.. left or right?

So did some of the things you suggested swamp rat and yes had 24vac to the gas modual that stoped when heat drop out . Had 24vac at th/grn and Val/grn which didn’t drop out. And found in the manual a note about not adjusting the gas at the regulator.?? See my attachments very confused about the...