Recent content by ggenovez

Hi all, I am trying to replace the collar on the SWG. video make it looks easy depin I've tried small screwdriver, large, needle nose pliers small and big. NOTHING I would appreciate any help

Hi all, I had a frost last year and the collar and plug on the cell cracked so I ordered the replacement parts collar and plug I have no idea how to remove the plug that stays at the end of the cell and the wire goes through it. Any thoughts?

Hi all, I need to replace the collar on the salt cell generator. I purchased the collar but not a replacement connector. Circupool says to cut the connector and reping to a new connector. I was hoping I can depin it by using an automotive depin tool. Anybody done this before? any idea what...

Hi all, I have a SJ-55 Chlorinator. today I noticed it was leaking from the back of the SWG. on closer look the blue plastic collar that holds the generator on and the wires go to the SWG was cracked. Any idea where to get a replacement?

Hi all I had a de4820 and dururing an unexpected frost the base cracked. New units are unavailable but I found a 6020 used. Brought it home and the upper pipe that connects to the bulkhead is broken. What wrench can I use to remove it. Also I have a 1.5hp motor. Should I use the 6020 or swap...

Thanks All. I can see chlorine being generated when it switches polarity. Agreed I've gotten my money's worth out of the cell. I will reach out to compupool and see if they're willing to give me a deal on a replaceement. if not, then what is the recommendation? also, what size for a 15000 gal pool?

Here you go

Some. More when it's on polarity 2. But not enough to catch up with demand

Hi all, I have a compupool cpsg16 I purchased in 2013. been a good system, but lately it's acting up. I get a low salt fault, even though I have 3300 PPM of salt. 3500 is stoic. So I calibrated the system, and went from 11 to 50. That got the sensor to turn off the low salt light, most of the...

Yes. regulator that came with the pool. Dedicated skipper. No adjuments in front of the pool. There is a return line with a polisher? that's disconnected.

Hi all, I just bought a zodiac mx6. Plugged it in and the flow valve collapses right away. Even fully adjusted. Any thoughts on this? Inground, salt, Hayward superpump 1.5 hp and Hayward de filter. 15000 gallons Thanks in advance

Yeah, I've tried 0 adhesive and it comes right out. Factory had but some blue adhesive that was a real pain to remove but stayed in place. Wish I knew what that was.

Ok. I think I've figured out the root cause of the problem. WHen I removed the last spider gasket, I see an excess of adhesive on the channels. This happened even though I pressed down hard on all the spokes of the spider gasket. I guess the real question is how little adhesive do I need to put?

Yes to all