Recent content by futurebeowulf

Hi all. Just an update, as it happened again. This time, I was told the actuators are discontinued and received ones without all the light (just a switch) working fine so far.

Howdy, I have a very similar problem and with a 3.03 firmware. Could you recommend a means to update the firmware? I did not find a way to do it (yet) Thanks.

Hi all. I called Pentair who then sent a Pool technician out. The tech said that this flashing light & steady service light means that the actuator has an electronic fault. So yes, it's broken. And in my case, it was replaced as it was still under warranty.

I am also having the same issue. I’m going to call Pentair as I cannot find any troubleshooting codes on this. In meantime, did y’all find out what may be this issue? Or is it just broken? Thanks

One follow-up question... Why are there 7 or so AUX circuits to setup in AUX circuits? (They seem to match up with the number for plugin on the board) Are they related? FYI, Most of the other circuits I have are here too, like the lights, blower... Should they also be "feature" circuits or...

Hi all! The issue was resolved, but it was a different issue. First I checked the setup and the actuators were in the right spots, and then I went ahead created a new circuit for the water feature. In so doing, I had two options, one for "generic" and another for "spillway"... For some reason...

Thanks all. Yes, we have it in "AUX" vs. a separate feature. We'll see if the helps and walk through some of the other ideas. I'm impressed. Stay tuned!

Thanks for the fast reply. I checked the RS-485 address from the Intellicenter panel, and one is set to 1, the other 2. I've attached a couple photos. They seem to be set correctly (but I'm learning). Note: I failed to mention that when they were first ran last week, all worked as planned...

Hi all! This is my first post, and I'm a complete newbie on pools, but I am enjoying reading these posts, and look forward to learning and helping more in the future. Today my pool installer and I encountered an interesting issue on my new pool/spa. He'll call Pentair on Monday, but I thought...