Recent content by FrozenPoolboy

update: talked to the pool tech, he said it doesn’t matter in my case what it defaults to when it is turned on from the aqua link, so should be good to go. Thanks again for the help

Gotcha, thanks for checking, seems I need to flip/switch an aqua link config to trigger the pool light versus the spa light

Thanks for checking, i use that red/4 wire hook up to the RS 485 Aqualink as well. On the JXI on the advance setting REMOTE is off, with any remote setting high-low, TSTAT, Off , the PDA turns the heater on and in all three instances the spa light is the one lit up.

Probably not as it kicks the variable speed pump up, just thought it was odd since prior the pool icon would be lit instead of the spa one. In addition just curious to see how that is reprogrammed on the JXI since that was the only piece of the pool system i factory reset.

Recently had a “ Fault - High Flue” error on my Jandy JXI , bought a new Flue sensor and installed it. Error wouldn’t clear so i cleared it out by holding pool, menu, spa button for 7 seconds, go to load defaults , finished , error cleared. Manually verify heater starts up no errors and runs for...