Recent content by Frankie5esr

Just in case someone else has the same issue. It seems to be related to water pressure. I have to backwash the sand filter to get rid of the sound.

I have a mesh cover too. I have 25,000 gallon pool. I SLAM and run the pool robot and it will clear in 1-2 days.

I’m running a replaced brand new natural gas heater and it’s the same size BTU. Previous one didn’t make this sound.

when the heater stops heating the sound stops immediately.

Sounds more like a howling sound. I uploaded a video to YouTube.

Hey did you figure it out? I may have the same issue as you.

Hi just got a new rheem pool heater. After it starts up it starts to make a whistling sound like it’s haunted. I saw other thread where people have variable speed pumps and increased the speed to get rid of the sound. I have a single speed pump so I can’t increase the speed. I did notice if I...

Yeah is it difficult to change that out?

I inspected everything and everything looks fine. No wires are chewed up.

Thanks appreciate the help!

Hi Everyone, I have a Raypak RP2100 pool heater. When i turn it on it will start up fine but then it will go to SPRK and re-ignite. I would say it does this every 20-30 seconds. Any ideas where I should start looking to see where the issue is?

My setup is a 1hp Hayward super flo with 1 1/2 pipping to one skimmer. Water level is fine at the skimmer and I replace all of the piping above ground. Is it possible that the pump is too strong that it’s sucking in air?

Hi Guys, For the past season being a first time pool owner I've been living with priming issues and air bubbles in the pump basket. Everything leads back to the suction side and sucking in air. I've done everything from running water over the pipes, replacing all the piping above ground, water...

Hi Jim, I eventually get the pump to prime so could it still be the "square-ring":p? Thanks, Frankie

Hi All, As i talk with some pool owners about priming their pump they have all told me that their pump primes fairly quickly. It take's me at least 20-30 mins to prime my pump. The steps I take are to open pot cover, fill with water, close pot, turn on, wait 30-60 seconds and I keep repeating...