Recent content by Forest Cove

Thanks Jim, You have me rethinking the changeover to chlorine. As for my pump issues, seems as though the rpm settings had been "lost" as you surmised. I have screen logic config app on my iphone as they did not have a Mac version at the time i needed it. my pool is 20,000 gallons so i need...

Thanks again Jim, as for the salt corrosion issue, is it your opinion the 'poor quality stone', which i agree I have, corrode the same whether it is a salt or chlorine pool? what type of stone do you have and is your pool salt or chlorine? Now back to my pump issue. I did go into my screen...

Thanks Jim, I got the connector apart without damage and reset the pump, but no change in it's action. When connected to the EasyTouch panel the pump display does show "Display Not Active". My current issue is that the pump seems to go through a high speed "prime" sequence and then the rpm...

I am trying to re-boot my pump. Does cable connector unplug(pull apart) or twist to unlock. I've gently tried both with no joy and I am concerned about damage. Thanks

Replaced ic40 this morning and the new one lights up and appears to be functioning properly. Thanks for everyone's support.

ic40

anyone suggesting the best place to purchase an IC40 cell?

Thanks,' if only the lights would come on, i could check usage. would pool supply stores have a cell tester?

Cell will be 3 yrs old next month. I had noticed the lights were out once before, and I disconnected (i.e. pulled) the AC power wire off the board, plugged it back in and the cell came back to life for a week or so. Then out again and stayed that way. Voltages were taken at the board both ac...

Does anyone know if a replacement transformer is available through Digikey or other suppliers vs. Pentair as the OEM? My salt cell lights are all off, the pcba surge board has a steady green light and is outputting 29-30vdc to the cell. Thinking this may be too low a voltage. My transformer...

It appears I joined the forum years ago, but only lurked for info vs. posted. More to come