Recent content by fiveintow

Never was able to fix that leak, but I ended up fixing the problem by just replacing the whole assembly.

Here's a picture of the leak I'm referring to - I can't find the part (I'm assuming a seal) I'd need to fix this. Can anyone point me in the right direction?

Update on this after poking around a bit I think the leak might be contributing to the issue. I took off the rear piece where the tail goes into the vacuum and it seems ok. Could it be the seal there? I haven’t been able to find the part for that piece can anyone tell me what it is?

Hello - I noticed over the past few weeks that the wheels on my Polaris 3900 began slowing down until finally now they don't spin at all. I can take it out of the water and give the wheels a helping push and they will spin for a while, but soon it stops again. Any ideas on what it could be...

This was it - after I installed the correct impeller it began working flawlessly. Thanks for the help!

I don't know actually. Before I realized the impeller needed to be replaced I ran it for a while though and it wasn't leaking. It only started leaking after I opened it up and replaced the seals and impeller.

Hello - I recently replaced the o-ring, seal and impeller on a pb4-60 booster pump. After turning the pump on it appeared to work, but after less than a minute water began gushing out of where the shaft goes into the volute (I'm not 100% sure I'm using the correct terminology). I noticed when...