Recent content by finsfanscott

Thanks again for all the input. Digging through some pool paperwork left behind, the Intellitouch controller was installed with the pool, filter and heater in 2007, along with a Max-E-Glas pump, I'm assuming it was a single speed pump. In Jan 2020 the Intellipro VSF pump, Spa side remote and...

Thanks again for the thoughts: 1 - I certainly shut the power off before taking the panels off and taking the pics, don't want to let the smoke out of the wires. 2 - Wondering if they used the Intellicom because there are motorized Jandy valves that are automated as well (when I hit the SPA...

Hello everyone, as promised here are some pics. And I have a greater (though not complete) understanding of what is going on. First the pump pics - as shown, you can see the Intellipro VSF pump is set to run with "Ext Crtl" and receives on/off and speed commands from the newly discovered...

Love this site and the replies. Thank you all for the intellectual curiosity. I will take pics tomorrow of the pump screen where I can change the External Control Prog 1/2 speeds and will take the cover off the outside panel and look for relays. Pretty sure @ajw22 and @Jimrahbe is/are on point...

Hello everyone, Purchased a home with older automation equipment. I have an Intellitouch panel inside and pretty sure an i5 outside (and a spa controller if that matters). Looks like firmware version 1.090 inside (UIC) and 1.160 outside (UOC). I have an Intelliflow VSF pump. It is set up for...