Recent content by falcor

Correct. Ah, good idea. We have more rain coming later this week. I'll try it then.

It goes to the gravel bed under the pool

We recently had a heavy rain, 2 to 3 inches in just a few hours, and it caused our pool water level to get really high. The water level was about half way up the coping. The water stayed roughly around the same level (I didn't mark it) for a few hours so I eventually went out and opened the...

That was it! I got connected to both pumps and saw that both were set to address 1. Switching the waterfall pump over to address 2, as expected by the panel, got it working the way it should. I also get speed, flow rate, and power usage information in the Pentair Home app which was never...

That's describing the touch screen on the pump, but I don't have a touch screen installed because I have the automation panel instead.

I see separate addresses 1 and 2 just like it shows at the panel, but it's not clear to me whether this is what the automation thinks they should be or if this is the pump reporting the actual value.

Ah, OK. Here is the info for all circuits and the details for the waterfall. My pumps don't have that unless they are hiding under the bottom where I can't see them. These are the stickers that look closest to that but maybe not what you're after.