Recent content by Evo-L

Hello TFP, I am trying to find a way to add a manual water filler to my pool, without dragging the hose out. I am thinking of running a water line from my homes plumbing, into one of my pools return lines at the equipment. I have 2” piping. Would this work? I am thinking I would Tee into...

Thanks everyone. I was able to get the correct dip switches set correctly and learned how heat pumps operate. I now will keep the pool temp setting below the pool temp unless I want the pool heated. Then I can switch to spa mode and click on spa heater which will use the spa temp setting and...

Thanks so much. I will look into all of this now. Its as clear as mud haha.

You may be right, Let me think about that. How would it work with the chiller? Wouldn’t it always be heating or cooling? What would be the point of the spa heat and pool heat buttons? Also, when I have the HP on, it raises the VSP speed up to 2750, which never seems to change. Now I’m...

Yes, I will have to do that, I was hoping to get it sorted over the weekend as everyone is closed. The pool startup guy whos supposed to set all this stuff up did a half Rear job, so Im not going to bother with him anymore. Ill have Jandys warranty people do it.

I am not sure if I powered everything off before I flipped the dip switches, but I have since done a power on/off cycle while testing the system. I was reading in the Aqualink RS manual and it talks about pool heaters, heat pumps, and solar heaters - all having different setups. It made me...

Ive just discovered the "pool equipment setup guy" came out and added a temp sensor thats plugged into the solar temp sensor spot. This makes me think hes set this heat pump up as some solar type thing. Why would I have a solar temp sensor without a solar system? Im about to reset everything...

I did flip those two dip switches to on. It doesn’t seem like anything has changed within the system. After, I tried turning on SPA MODE first within the app, then I turn on SPA HEATER, like usual. Unfortunately the same thing seems to be happening, no heat pump activation. It will change to spa...

Thanks so much. I will give that a try.

The heater does say Jandy Remote Online on it

Did you ever get this sorted out? I think I am having the same issue.

EDIT - Thanks everyone. I was able to get the dip switches set correctly and learned how heat pumps operate. I now will keep the pool temp setting below the pool temp unless I want the pool heated. Then I can switch to spa mode and click on spa heater which will use the spa temp setting and heat...

No enclosure. Attached a photo. Patio is still being installed so its a mess!

Oh ok. I didn’t know. What should I look Into? Thanks