Recent content by erichanus

  1. E

    Help with low ph

    Just trying to get better balanced water.
  2. E

    Help with low ph

    So I aireate the water with the return jet during the run cycle over the last couple days then I let it run most of the day today while the automatic cleaner did it's thing for the first time this year. The PH is now 7.8. Now that I know I can effectively raise the PH by aireate the water I may...
  3. E

    Help with low ph

    The return is strong enough to break the surface. I will try that to see if I can get it up to a measurable number. I have borax in my inventory but I a trying to keep the TA down or at least not any higher than it already is.
  4. E

    Help with low ph

    Tested fill water today. PH is 7.2 TA is 80 Pool water CYA between 30-40 CC 0 FC 10 PH below 7 TA 100 So I took a look at the stabilizer I used and it says 100% cyanuric acid. Is this correct or is this the cause of my problem? If it is, what is the best way to fix it?
  5. E

    Help with low ph

    I will check fill water and pool water this afternoon. TA always seemed to stay the same last year and I just left PH low most of the time. I had a good handle on the CC last year so I want to get better with this part this year. These are the first numbers from this year but it was the same...
  6. E

    Help with low ph

    I did get a refill kit last month. Havn't replace all reagents from last year yet. I do have a question though. The 0004 I have now says residential use and 0014 came in the kit says commercial use. Any difference? Should I order the 0004 or does the 0014 work the same? I have not used the...
  7. E

    Help with low ph

    None of the above.
  8. E

    Help with low ph

    I will test and post results tomorrow. (Current pool water and tap water) I only use methods from this site. Should I just try to raise the ph with the borax and monitor daily like the chlorine? Do I need to be or ride about higher TA?
  9. E

    Help with low ph

    Current numbers are CYA 50 FC 10 CC 0 PH LESS THAN 7 TA 100 This is my 2nd year with our new pool. Using BBB. The PH has always been low and I can raise it with borax. But it always goes back down. Should just raise it and see where the TA goes? Should I be concerned about higher TA? I don't...
  10. E

    Remove Water On Top of Pool Cover

    I used the siphon method but I used my pool vacuum hose. It was much faster than the pump I bought. The pump really wasn't big enough for what I needed. Found out the hard way...
  11. E

    PH dropping

    Thank you!
  12. E

    PH dropping

    10% bleach
  13. E

    PH dropping

    These are the numbers from this morning. FC 4.0 CC .5 PH 7.0 TA 90 CH 80 CYA 40 Opened new pool on 7/4. Everything has been fine and water is crystal clear. I have been slowly fine tuning the water balance. My question is the TA is on the high side but the PH keeps falling. Why would PH fall...
  14. E

    Pool Electrical questions

    Awesome, thank you! I already have the GFCI breaker. Can I return it and just use a GFCI outlet?
  15. E

    Pool Electrical questions

    Our neighbors electric was approved with no shutoff. They just required all the other basics for code. Their pool is less than 20ft from the house plug so it would meet the requirement for the convenience plug. Our plug is about 40ft from pool and electric run is about 70ft from house. I am...