Recent content by dradam

Novice here, buy I have your system. One all leads are reconnected you will have to reprogram your settings on the easy touch. When in Auto mode your pump will defer to those settings. It is a bit of a pain to program on the small screen of the easy touch. You might want to add a screenlogic...

Thank you for this detailed and thorough explaination. Bicarb will be much easier for me to source.

Thank you. Won't baking soda bring the TA too high compared to soda ash ?

Thank you ,I will check th CH at opening.

Haven't opened yet but my CH usually runs about 400 and I keep ph at 7.5 , TA 100 with a bicarb and borax buffer.

Looking to do a no drain acid wash before startup this spring. My WetEdge luna quartz finish has become hazy over the past 10 years. Inspection under water seems to show that the plaster between the agregate has overgrown the agregate dulling it. I suspect this is more just a problem with the...

Sent you a private message

End of year 11- a great trouble free year. Replaced PH probe this year. Did not replace pool cover yet but will likely do it next year. ( I hope it fits ! it has been in my shed for 2 years) Very little maintainence this year -- just refilled the acid tank once or twice. Did not even add more...

2024 10 year follow up. August 21, 2024. I purchased a new cover from my vendor to replace my cover in 2023. The rope built into the cover near the leading edge had eroded. Opening fully, the cover would come out of the track. I found though that just leaving the cover out 6 inches ( rope stays...

Pool Cover Specialists, but my understanding is that it was bought by Latham who owns coverstar.

Had an electrician review the existing wiring. because all is enclosed in NM conduit and above ground he says it meets code in my jurisdiction. He says insulated ground is prefered but not mandatory. Tested the connections and gfci -- good to go. Thanks to all for your replies.

Ground wire is uninsulated Insulation in simplex not wet certified?

Replacing an existing 18 year old outdoor hot tub wired by an electrician. Have discovered that from outdoor 240 V 50A GFCI disconnect - 6awg simplex with 8awg uninsulated ground was run in above ground secured 1" PVC coupled to 3/4" liquid tight Flex pv c - then into the tub controller. Same...

Might be interesting to know. It is unlikely that both were bad. I am glad you are still using the wireless. In my early install I had a buried data line from the ET directly connected to the PA. Somehow a lightning strike nearby must have found the buried cable. It fried my PA ( The Brick)...

Hope you got it. The new system, pump on the tank, and older system, pump on the intellichem use different tubing in the stenner pump and this would effect the roller correctly compressing the tubing. In your photo I see no acid output to the return line, but I suspect you know that. I put the...