Recent content by Discobrian24

With a milivolt system it is important to keep all wire connectors clean and free of corrosion. I usually replace corroded connections each time I open the pool for the year. My heater is a 1994 and still works great. Never bypass safeties...

Ok the one I found would not work as the connection to the copper line was different so i just took the good switch off the new one and screwed it to the old one.

Thanks found one, but if that doesnt work I will use the link you provided.. Greatly appreciated!!

It is the electrical part of the switch. I think the tab broke off for the wire. I will have to look into it tonight.

Hey guys I was sticker shocked when I researched a new pressure switch for my heater. I saw prices over $100. My question is, is there a cheaper alternative to use in my application?? The part number of the original switch is EE05-Q11. Thanks in advance!

Is this something that can be added after an AGP is already up??

I just remove the drain plug at the bottom of mine and run. It shoots the water out at a high rate. I may even this year add a valve to this and eliminate the cap all together. You can also take the filter out before doing this. When I re-plumb with PVC this year I am adding a shut off to...

And I love that walkway to the deck, keeps grass and other stuff out of the pool. Fill the bottom half of that with gravel for drainage.

Nice!!

All I do is simply pull one side out of its holder when there are a few swimmers and walk it over to one side of the pool and rest it on the rail. If there is gonna be a day of swimmin I remove it and hang it on hangers I have mounted to my fence. LOVE IT!! Will say that it does sag in the...

I have this one on a 21' pool.. http://www.shoplitehouse.com/store/prod ... %27-Pools/ LOOOOVE it, better than lugging the cover on and off. Before this I cut my cover in half which made it easier to move, but didnt eliminate the clippings and other stuff that it put back into the pool.

I don't understand the need for a 400,000 btu heater on an 18 ft pool?? I have a 21 ft round and heat with a 150,000 BTU heater. It does quite well. Gas bills are nuts, but that is part of the price I guess. You could look around EBay as well as Craigslist for a used heater. Mine is like 12...

To swing it u just pull the pins and leave 1 end in. Pick up the other and move it. Mine has the 3 inch pole. It sags a little. I think with the 4 inch tube it would be better.

Thats the one I have!! I love it just for the fact that it is easier than folding the cover like we used to do. I can take it completely off or simply swing it away to 1 side of the pool.

I agree mine has shot out a few times. Replaced the ring and eyeball while I was there and all is well.