Recent content by dbryda

Hello, I was wondering what might be a good transition for pavers to the standard while aluminum coping. The coping is a bit bent as you can see, but not from these pavers. Pool is 30+ years old and used to be concrete apron all the way around and I believe cracks in concrete over time caused...

It was professionally installed actually, back in early 2000. I think they make a colored sikaflex that would be like a beige so it may not be bad. Would concrete be too tight in joint?

Hello, I am closing my pool in a few weeks and was looking for some feedback on how to better seal this, as the polymeric sand erroded a bit with kids splashing. Would an elastomeric caulk work (ie. SikaFlex)? Thank you

Hi Everyone, I will be closing my pool in a few weeks and I was wondering if anyone had any ideas on how to better seal this, as the polymeric sand has error down. Before I fill it back up w/this, would a elastomeric caulk (ie. SikaFlex work better?) Thanks

Here's a similar picture. I'm looking to see how I can better seal this skimmer as some of the sand on side is erroded down a bit from kids splashing. Would SikaFlex work?

Hello, We have been at out house for a few years now and the pool has been there roughly 30+ years. It was originally installed with concrete apron, and removed in place of pavers in 2002. The pavers go to edge of pool (on sides), but in middle of 32' run it juts out about 2''. It is filled...