Recent content by Darko

Hi guys, my pool pump is hayward super II, motor is one year old. I went out of town for few weeks and when i came back basket was full majorly, i removed basket cleaned impeller from debrief as much as i could, used wire hanger and there was noting left anymore. A week later my pump started...

Thank you all so much , there is some real knowledge here , and yellow wire is from my lower speed i suppose .

this is diagram from new motor i was thinking connect my red wire to L2, blue to L1, and yellow to A, is this correct, i guess i just have fear of frying new motor , and also i wonder how will i be able to see if impeller is spinning in the right direction.

Thank you Dan, my pump is dual speed so ill have to somehow put this together, my understanding is that on my picture , red wire is 220 or common line , i just have to figure out is blue wire hi or low speed line , im not very good with electrical stuff.

HI everyone, I have Hayward super 2 pump, and after of years of rebuilding bearings and such i decided to buy new motor, so original motor was sp1620z2, i replaced with sts 1152r, now, i was used to reconnect wiring on old pump by taking a picture of old wiring, new motor has different set up...

My heater Hayward H400 is stuck in spa mode, buttons do not respond any more, so I'm assuming that keypad bezel is possibly broken. I looked online and this keypad bezels are quite expensive, between 200-300 dollars. 1. Are they difficult to replace , 2. And If i decide not to use heater at...

Hi Yoitsme, I use Cal-Hypo once a week, 8 oz each week, so 8 oz X 8 weeks = 64 oz which adds FC 41 * 0.7= 29 , and I got 600 thanks for response though

H i everyone, I just got my K-2006 kit today in mail , and I tested everything : Ph - 7.6 FC - 3 CC- probably bellow 0.5 ( I could barely tell that it was pink, I had to look for minutes, added one drop and it cleared) CYA - 35 TA - 100 Ch - 600 Should I be too worried with this...

Hi Jason, Thank you for the response first of all, 1)As far as pump running time goes, i tried to calculate, I kind of have a feeling that my pump is more than enough strong, so I don't have to run it for long hours. According to Hayward , i looked into this graph , and I'm not sure if...

bump

So Richard here is the video, i was kind of explaining along the way, sorry the video its a little shaky and blurry. I think that little hole that I was asking about is used when you vacuum pool, when I turn valve on oposite side of skimmer, where it says vacuum, it pulls all the water through...

Hi Richard,thanks for responding, I was going to make a detailed post , but then I ran into forum rule that you are not suppose to make post too long with too many questions, and there was limitation with pictures too, I will make a short youtube video, I think that's the easiest way to...