Recent content by csoukup6

$5.09 worth of o-rings and the leak has disappeared. Thanks for the info, I didn't realize the CVA24 mounted on top of the diverted valve. Saved me from spending a lot of extra cash for nothing. Took about 15 minutes to replace the o-rings.

I have the same problem. I think I'm going to replace the entire actuator since its 9 years old.

I have a Raypak 206A heater which is just over a year old and no power. Fired up the heater yesterday to bring the pool temp up a few degrees and I noticed the I wasn't getting any heated water. I went out to the unit and the display was blank like it had no power. I removed the cover and and...

Are you referring to the connection that I have circled in the photo? I believe its pretty straight. I believe you mean the connection being on a slight angle like the line I drew may cause the type of failure I had.

My pool equipment is on the side of my house so it's a little distance from the main drain. I wouldn't say an excessive distance(30ft). My pool filter PSI reads between 24psi to 32psi depending on which zone the paramount 6 port valve is running. I have 16 pop up in my paramount system. 1 zone...

It's not leaking from the pipes. It leaking from the chassis of the intellichlor. I'm wondering if there is too much pressure in my plumbing.

I replaced my Pentair IC40 SWG just over a year ago and I've had another failure. It's leaking from all around the seams. Has anyone had similar failures. Both of SWG failed in the exact same way.

Yes, I've drained water one time late today.

Living in west coast of Florida and its been raining none stop for 24 hrs and it looks like a few more days of heavy rain. What is the best thing to do after the rain stops?

I'm replacing my paramount 6 port module. After I removed the module I notice on the bottom it appears some type of gasket was applied. It was white in color and pretty deteriorated. Does anyone know what to use for the gasket?