Recent content by Cmrsun

Well… I was sitting here at work staring at that picture and thinking about my return hose dripping at the pump end when I realized my dripping return is on top. Honestly, I have never been so happy to make such a simple mistake. I ran home on lunch and swapped them in less than 30. Backwash is...

I’m going to change out the sand and inspect the laterals this weekend. I’ll get plenty of pics. Lol

A new spider gasket comes on the new port, right? I didn’t even pay that close attention to see if why I took out had the same pieces.

No, that was before the new one. I solved that problem but now I have this problem. Yes, I installed a whole new port. I detached hoses and removed the collar. Pulled off old port. Lubed the new o-ring and slid the new one on. Reattached hoses just as they were. Could I have lost sand with it...

I didn’t switch the hoses when I installed the new port like I read in other posts. I wish that was it. 😆 These are all I have at the moment. That’s actually the old port. Everything seemed fine until the water drop overnight and I saw it was coming out my backwash. I just don’t under what would...

I had a problem with water coming out the backwash when filtering. I replaced my multi port. It seems to be running fine on filter 12 psi. I went to check backwash and I have very little flow. Would a low sand level cause this? I’m going to replace the sand and check my laterals this weekend...