Recent content by chulaman

Thank you ajw22. Will this system work with my existing Mobile Touch or do I need a new controller? As it will be hard to direct wire ethernet and it is a bit far from my wireless routers do I need something else to boost wireless range?

someone suggested I bypass the relay to get power to the pump. I gave done so and the pump has power and communication but the intellitouch will still not turn on the pump. I am now thinking the i10+3d is faulty so unless folks have another idea, I am back to the intellicenter upgrades. I have...

Intelliflo VSF for pool, Intelliflo VS+SVRS for spa, 4 Intellibrites in the pool, 1 intellibrite in the spa, SAVI light set in spillway, 2 blowers for spa, multiple lighting circuits either direct 120 or to 12v transformers, is10 spa side remote, mobile touch wireless, 2 520285 valve actuator...

As I now have an i10+3d and i10x expansion kit what specific upgrade kits would I need?

The chip replacement did not do the trick. When I did the job there was a fried ant at the terminals of the rightmost socketed chip which I cleaned off. I am now presuming I must replace the main board. Any thoughts?

got it. I will try the chip replacement and see how it goes.

Thanks for your help.

I swapped out the OMRON relay just to be sure and that was not the culprit. Please clarify, are the UN2803's on the Intellitouch motherboard?

I have and Intellitouch i10+3d that will no longer turn on the spa. From what I can tell the relay is not getting trigger signal for some reason. I am presuming the board is bad but wondered if there could be something else.

I tested again this AM and this afternoon and everything seemed right but CYA which was not possible so I rechecked my test kit (TF-100). It turned out the R-0013 CYA Reagant had been accidentally swapped out with the R-7065 CYA Standard Solution. As to the two prior times my CYA disappeared...

I have a 34,500 gal pool in FL. I was running a Total Control system with a CC-15 cell that I switched about 1 month ago to percentage & ph due to my ORP control not functioning well. 3 times now I have had 25ppm -40 ppm of CYA rapidly go to 0ppm. Most recently I have been very stable at...

I have been running in Total Control mode with ORP disabled for about 10 days now. Oddly, I have the system set to 36% but it periodically displays 42%. Anyone know why? Thanks.

Thanks JasonLion.. Select System: pH control does not work but in Total Control mode with ORP disabled it does the trick. I still bugs me that Autopilot has not figured out this issue as it has been know almost 3 years.

I have a total control with a CC-15 cell that went operational toward the end of last summer. I have discovered the same problem as others, i.e., during heavy demand, whenever the cell runs ORP readings decrease. I spoke @ length with an engineer @ Autopilot who diagnosed my problem as dissolved...