Recent content by Chrispatterson99

Thanks for the help. Looks like I am dropping another 800 into this money pit

Well it was free(ish) with my home warranty. But I did replace the dc cable at the same time. Where is the power supply?

Ah misunderstood your question. No, the sensor was not replaced

Oh and I am not getting error code 171 like it says in the troubleshooting guide

Yes the whole cell was replaced including the body and the cable

What unit would you recommend. I just put a new back board on and it still has the same error. I also noticed that when trying to test the cell voltage it read zero. Could that just be because the cell is not reading any salt?

The unit is approximately 10 years old the cell was replaced last year. I have been in this house for three summers now I had a problem two summers ago with a back board voltage issue. There was a fried connection. Replaced the back board and it worked perfectly. Now I am getting this issue...

Bumo

So i have had the pool open for a couple weeks now and have gotten all the chemicals right and temp above 70, but the SWG is giving me these errors (low salt and High cell current and cell voltage below 19v. The back board was replaced by me two summers ago and has been working fine. As for the...

I have a call into the home warranty company. The pool equipment to include the salt/electrolysis system is covered. So hopefully this will only cost me 75 bucks. But if for some reason they won’t replace it then I will be going with amazon as they have the lowest price I have seen. Thanks rob...

Ha ha so! Where do I begin? How bout the beginning. I turned off the power (safety first). Then unplugged the DC cable from the cell. there was no more corrosion than the last time. So I used some carb and choke cleaner (non corrosive and dries/evaporates quickly). Then I wire brushed the...