Recent content by Chgorob1

It appears to be. Those pages say nothing about this error message.

Has anyone familiar with Pentair IntelliCenter know what this err message means? See photo It also shows if I do solar preferred. Does not appear if I select Mastertemp400 heater, only solar

Is this the breaker that I want to use? Is the one I have now Eaton? this is Siemens and Dual pole (20 amp each like I have now) with GFCI and says it’s for spas etc i’ll have my electrician install it but I want to make sure I get the part and get it right.

OK so I deleted the single speed pump and left it as a aux generic feature. As I press the button for waterfall it goes on and off., seems to work fine . There is no control cable or RS485 to it. I disconnected the 485 cable then reset the variable speed pump to factory settings because I had...

OK so I will show you the screens on the IntelliCenter itself as well as screenshots of my phone. My phone seems to show communication. The last 2 are cell phone screenshots. You will also notice when the pump is running only the filter and namely not the booster pump for the Polaris or the...

Thank you I will make sure I get the right equipment

Tried 1725 and it was too slow. Noticeably better at 2000 I may go up just a little bit more, FYI.

OK lmk. Also I just added a 24 hour schedule for just the pool filter pump to run at low speed. Because it’s 24 hours it instantly activated and as of five minutes later still has that no communication error. So apparently I still have some kind of issue . I especially wanted to make sure it...