Recent content by caribbeancruzer

I will work to get a set of test results, the pool was cloudy in general regardless what was running. I was out the past week and when I returned I found very clear water but areas of grey on the bottom of the pool, once that was disturbed the pool went back to cloudy. The pump filter was also...

The system is working ng good for me, added too much salt even know it was recommended amount. The water is a bit cloudy and more so after use but is not enough to warrant a drain, can lightly taste it and no irritation of eyes so i can't complain.

You would think this would work but the system just creates more after setting it back down level.

Re: Air in Intex SWG System Thanks for the feedback, I just started it so will have to wait to see if it is producing chlorine. Was just used to not seeing air bubbles coming out the return in the pool with just the filter so thought maybe something was wrong.

Thanks RobbieH, any idea where/how to disable this on the 2012 model. From the sounds of it I don't want it.

I just setup a Intex SWCG system and after turning it on, I notice air in two different locations. I can tilt the unit to have the air escape out the return line but then small bubbles form until there is noticeable air in the system again. I have ensured all seals are tight, I am wondering if...

I just installed a unit but have not turned it on as I am letting the salt mix, your saying don't use the copper function? What is the pro/con of it?

Did you figure out the part? Just bought a system today and installed, no part like that in the box. But the instructions were terrible and nothing really seemed to match for us... just common sense to get it together.