Recent content by bryangauvin

The antenna is about 12 feet away. However, this is not wireless interference. It's coming through the wiring from the pump into the main board basically scrambling the serial data so the app/webpage you use to operate the pump cant get a solid stream of data to interpret.

Ok, so Pool guy just left. No resolution yet, however, the issue appears to be with the drive on the pump creating interference in the signal. He's going back to the shop to ask the other techs if they have ever seen this or how to fix. In fact, If I unplug the 4 pin to the pump the iaqualink...

Chris, This software works perfectly with a raspberry PI, I helped a buddy set it up on his system no issue. Here is the link to the project GitHub - sfeakes/AqualinkD: Daemon to control Jandy Aqualink RS pool equipment from any home automation hub (Alexa, Homekit Siri, Home Assistant...

Hello all, I have learned so much reading this group. Thank you all. I have a problem where when the RS is in auto mode the iaqualink shows "Waiting for Connection". Thinking this was an issue with the iaqualink AGAIN, second unit in 5 years. I decided to do a DIY installation instead. Found...

No its the newest one. There is no Daughterboard. Its the new one with the inline box

I have a Jandy Salt system. The system has been showing salt levels all over the map. One minute it shows 4200, the next 0, then 1600, then ...... I have already replaced both the salt cell & sensor. Any idea why it would be bouncing around like this and how to get it dialed in and not so wild...

Ok, so I sucked it up and bought a new flow sensor. Seems to be working fine for the FLOW issue now. However, not its bouncing all over the map for Salt readings. One minute it shows 0, the next 4200, the next 1900 and says low salt. Any idea how to fix this?

Ok so that seemed to work, however, this am now its back to showing No Flow.

Ive tried both A & B. Same results

I am currently on B. Box version 02110a1005

model number is H0406200

Jim, Flow is not an issue. Pool is running fine. RPM 2250, everything is clean. - - - Updated - - - James, The sensor is less than a 2 years old. I saw how you "reset" the flow on the old ones with a daughterboard, do you all know any way to do it with this newer one?

Hello all, I have a R0452500 Jandy Sensor. My Jandy unit is displaying "No Flow" Does anyone know how to reset this? There is no daughterboard on these newer units. Its the one that has that weird box for no reason that hangs below the box.