Recent content by bizzle

...

...

...

Hahaha, no the pool's out in the desert. The price was $750 compared to over $1,000 (most hovering around $1,400) for the IC60...if it's in stock, which I haven't found any lately anyway.

Yeah, I need to put a cover over my pool pad as of a couple years ago. :)

I went with a Splash IRCF60 (Amazon.com: SPLASH IRCF60 - Replacement Salt Cell for Pentair IntelliChlor IC60 : Patio, Lawn & Garden), which is reported to be a generic Intellichlor. The threads matched so no cutting of plumbing was necessary and the lead connected to the easy touch same as the...

Turning the chlorinator on/off repeatedly kept it working through the weekend. The plates were fine so it's either the electronics in the Intellichlor or the easy touch. Either way, this dying in 1.5 years and also being the warranty replacement for another cell that lasted 1.5 years I just said...

The app only allows one log so you either have to delete the log you have to put another set of measurements in or go into Logs and edit the log that exists. You can't change the numbers from the Overview tab. There's a lot of people offering advice that know much more than I do so I will only...

Hahaha, sure put me on the list! The Cell light is flashing and parameters are correct, fresh acid wash as of last night, no debris, Pentair telling me to take a sample in to the pool store for a phosphates read... To be clear, this wasn't intended to be a request for help but I'm willing to...

I don't need help often, but when I do it tends to be because of the SWG. I installed an IC60 in 3/2018, which was courtesy replaced by Pentair 5/2020. That cell just died yesterday. As I'm searching around for solutions to my blinking green light I'm noting all of the posts of other users who...

I think you're right.

I put a lot of information in my post so my questions might be overlooked.

Here are my pool data (relevant stats are in my sig): FC: 12 pH: 7.0 TA: 110 CH: 300 CYA: 30 Salt: 3000 Temp: 82 F CSI: -0.59 These are the parameters as of this afternoon. I brought the CYA up to 30 instead of 0 and started another SLAM. I was going to do a complete SLAM and then spike it to...

Would you be willing to rent out or loan your equipment? I'd like to do this update, as well.

I'm a faculty member so I can obtain a discounted software license, but is anyone renting/lending the hardware units out for updates instead of each of us building a kit?