Recent content by bigwig001

Yeah I was convinced it was something I did so just went and rechecked everything. Turns out I had swapped the power cables between my D-link hub and the Wifi Adapter for the Screenlogic. One is 10VDC out and one is 12VDC. Looks like I am back on the right track. Now to get everything setup...

I have attempted this as well, however no success. I cannot get either of the protocol adapters to be recognized by any combination of cabling, ports on my switch, directly into my router, etc. The Pentair help desk was no use either. I simply don't understand how 2 adapters could have the...

Curious with this as well. Same issue, except ours worked fine initially. Moved my modem, router and switch across my office, and no comms. Sent a new adapter. Same problem.

Thanks Jim! I really appreciate your help. Woke this am and the SWCG was off. Waited till 0800 and it is now on. So odd that the PB didn't know this! But the pump issue seems to explain that they perhaps have some learning to do on the equipment side. Again, I appreciate all your help...

Inside of the EasyTouch

Thanks for the insight. Question I still have in my mind then, is if the cell turns off as it typically has, how do I turn it back on without doing it manually? We do have a water feature, which I understand needs the higher RPM, hence the frustration with the inability to control via the...

Thanks for all your help! SuperFlo was manufactured 9/8/2020, so looks like that is confirming what you stated with the lack of RS-485. I confirmed with them as well that they realized it was manufactured too late. High speed is 3000 RPM, medium is 1800 and low is 1200, just based on PB...

Hi All! New pool owner, construction complete 27 May 2021. 16k gallon SW Pool. I did a search but cannot locate my issues. 1. Our system consists of Pentair IC40 SWG, Pentair Superflo VST Pump, and Pentair Easytouch Control System for Pool and Spa 5K42 (no spa with our build). 2. Our pool...

Greetings all! I am new to the forum, but appreciate all the research I have been able to glean from reading thus far. My wife and I have found our PB after many months of calls, meetings, no-shows, finger pointing, etc. We have found that this is a "unique" industry and no two builders will...