Recent content by bchristex

After I run my Dolphin robot the basket has been having about 2 cups of white goo in it. I saw on another thread I should taste to see if it is salt which it is not so I am assuming plaster. If you can please help me understand what I might do My numbers are: FC 6 PH 7.5 TA 100 CYA 50 CH...

Thanks all for your help. I posted several questions along the way for my install and thankful for the help I received especially from Jimrahbe on wiring and plumbing. In looking at pictures of others implementation I may have taken the Pentair instructions a bit too literal and might have done...

Thanks for your comment I am going ahead and wiring all 4

Thanks for the tip Jim I appreciate all your experience and wisdom. I took your advice Home Depot had 4 strand sprinkler wire by the foot so I bought it and wired it up. Of course the colors didnt match but thats OK. I still havent got my pool open so I just wired all 4 and spliced them together...

Thank you for responding. I am less than a novice at wiring, i am only attempting to include my chlorinator to my timer. I and my pool builder had to wait 4 weeks before we could get the city inspector to finally come out and inspect the pool wiring so the job could continue so I am a bit...

Thanks Jim. I have been to Lowes looking for rj 485 wire with no luck so I am off to Home Depot tomorrow. My pool is not yet opened but I will try wiring only the green and yellow wires from the Intellichlor transformer. Thanks again

I ordered and finally received my IC60 and power center and spent the last several hours wiring the power center using my understanding of Marty and Jim's instructions. Just hoping to see if I am on the right track. The red circles on the breakers are the lines I ran from the Pentair pump 11028...

Thanks Jim sorry it took so long to reply I was indeed not in AUTO mode. I recently purchased a Screenlogic system and most likely will be bugging you again Thank you

[/GALLERY] Thanks for that. It most definitely was operator error. Sorry I didnt thank you sooner as soon as you posted I ran out and changed to AUTO mode which solved my problem Thanks again

I purchased an Intelliflo 011028 online and am trying to install it. It went pretty good except I got the power to it and ran the communication 485 cable to an Easytouch 8 but it does not show since I can run the pump by the scheduler on the pump timer . I am replacing a Whisperflo single...