Recent content by atripodi24

  1. A

    Intellichlor Cell Light Flashing

    It wasn't a replacement cell, it was the initial install of the salt generator system
  2. A

    Intellichlor Cell Light Flashing

    My husband's friend came over last night and he helped me clean the cell. It didn't look bad. After turning it back on, the Cell light was still blinking. So he did some quick Google-ing and said we could try adding salt. Salt was at 3000, so we added 3 bags. It brought the salt to where it...
  3. A

    Intellichlor Cell Light Flashing

    How long should the cell last? We installed ours in May 2022, and today it is blinking green. Checked my calcium hardness and it's at 80. PH is high at 8.0 and alkalinity is also high at 110. CYA is at 40. Salt is at 3000, but I figure I need to get the other stuff balanced and the cell fixed...
  4. A

    TA High, PH slightly low

    Ok great, thank you!!
  5. A

    TA High, PH slightly low

    Hi all, We opened our pool two days ago, much later than we usually open it and it was pretty swampy. We're making great progress and SLAMing is going well. When we opened, PH was 7.0 (possibly lower, test doesn't go below 7.0) and TA was 70. Been trying to get the PH up and it's now at 7.4...
  6. IMG_6548.jpeg

    IMG_6548.jpeg

  7. A

    Cracks Along Skimmer Basket Housing

    We don't usually add any weekly. We keep an eye on the level of course, but with rain, we usually never have to add any ourselves except after we open it.
  8. A

    Cracks Along Skimmer Basket Housing

    Thank you! The pool was installed in 1997, is it likely they'd be from settling after 25 years? Or also could be just after 25 years the equipment is starting to breakdown? I'm assuming it's a big to do to completely replace it?
  9. A

    Cracks Along Skimmer Basket Housing

    My husband noticed these cracks along the housing for the skimmer basket. Two questions, he noticed the water level a little low and is wondering if it could be from these cracks? And 2nd, short of draining some water, he has some under water epoxy and was contemplating trying that to at least...
  10. image000002.JPG

    image000002.JPG

  11. image000001.JPG

    image000001.JPG

  12. image000000.JPG

    image000000.JPG

  13. A

    New to SWG- Question regarding balancing

    Yes, it's for sure sodium carbonate. So I should be good with just that and not also adding sodium bicarbonate too to raise the TA?
  14. A

    New to SWG- Question regarding balancing

    Hi all! We recently installed a SWG system for our pool, and we just opened the pool today. I know we need to balance everything first and then add some liquid chlorine before we add the salt and get the SWG going. At opening these were my levels: FC- 0 PH- 6.8 TA- 40 CYA- 30 I have sodium...
  15. A

    Lack of Liquid Chlorine

    That is great! I will definitely reach out to Add-On Pools! Leslie's didn't have any when my husband went this past weekend.