Recent content by Andaman Andy

Thank you! works now, i didn't wire up the box and the guy that did seemed in a hurry, looks like he may of disturbed something.

Hi, thanks for the reply, how do i reset the board?

Ok, so i finally purchased a new PCB, swapped over from the old one, powered up and ..... all the LED's started blinking and i could hear the relays clicking on and off, do i need to replace another part or is there something i have done wrong?

Yellow fuse ok Thermistor sized by guy in electronics shop, did this before and it lasted 2+ years, before blowing again. Need to unplug other unit and plug this one in the get diagnostic readings.

Thermistor is two pieces, i could not get the same part here so used 2 to get the same rating, did this before and it lasted two years before i had another power spike, board now has power after i replaced with new ones (Didn't before) Would have to wire it back up to get diagnostic readings...

Picture of board, locally sourced thermistor fitted, same ones as 2 years ago.

Does anyone know if there is a "Re-set" procedure or is another component damaged on the board? i inspected it and couldn't visibly see anything burnt.

I swapped out the control unit not the cell.

Hi, New to the forums and searched around a bit but couldn't find an answer so apologies if this has been covered before. Recently had a "Brown out" with my electric supply and it blew the thermistor on the PCB, i have had this problem before so got a new one soldered back on place of the old...